Tools Needed

From my experience I have compiled a list of tools you will need or probably need for your installation. If you don’t have it then save yourself the time and go get it before you get started.

  • Drill Bits (get an assortment pack, you will need a couple of different sizes)
  • Drill (Corded or Cordless will work)
  • Center punch
  • Socket and rachet kit (Metric kit)
  • Open ended wrenches (metric)
  • Crescent Wrench
  • Nut driver kit  (Metric, bonus but not a must)
  • Electrical meter for testing circuits and identifying the wires you will need
  • Wiring diagrams (most vehicle manuals chilton/haynes will have wiring diagrams. Check before you buy)
  • Soldering Iron W/electrical solder that contains flux
  • Heat sheild
  • Torch/lighter
  • Electrical Tape
  • Zip Ties
  • Diagonal Cutters
  • Wire Strippers
  • Vice
  • Hammer
  • Channel locks
  • Possible a tap and die set for Injector installation (typically a 6mm tap)